Problems with "gradm -D"

[sekko]

Hi guys!
I have a problem while trying to disable GrSecurity (gradm -D) when I login on the server from a remote machine via ssh. It only happens when I run "gradm -E" by INIT (during the boot startup). It works fine if I enable grsec from the same remote host; in that case I can also perform "gradm -D".
For istance, I do not have any error or "deny" into the logs. It just says "wrong password" all of the times.

Any suggestion?

Thanks in advance,
Claudio

[spender]

If there are no messages in the logs, it implies that you're not able to talk to the /dev/grsec device. This means you probably haven't set up your policy properly. If you can mail it to spender@grsecurity.net, I can tell you what the problem with it is.

-Brad